Inverter Info

aurora protocol http://www.curtronics.com/Solar/
Post Reply
lollo
Posts: 5
Joined: Tue Jan 21, 2014 2:40 pm

Inverter Info

Post by lollo » Tue Jan 21, 2014 2:49 pm

Hi,
i've installed 123solar on my raspberry Pi today with a usb to rs485 chip connected to a Aurora PVI-6.0-OUTD

in the web page if I go to the Info's section there are the Inverter Info but there the Inverter Version is the PVI-3.0-OUTD.

is it possible to change it to the correct model??

jeanmarc
Posts: 1858
Joined: Thu Aug 29, 2013 7:16 am

Re: Inverter Info

Post by jeanmarc » Tue Jan 21, 2014 3:44 pm

There is a problem in the last (?) version of aurora, i get the same problem. It has been reported to Curt.
The info is not coming from 123s..

lollo
Posts: 5
Joined: Tue Jan 21, 2014 2:40 pm

Re: Inverter Info

Post by lollo » Tue Jan 21, 2014 6:51 pm

ok.

Thank you :D

jeanmarc
Posts: 1858
Joined: Thu Aug 29, 2013 7:16 am

Re: Inverter Info

Post by jeanmarc » Tue Jan 21, 2014 9:24 pm

Maybe it may help if you send him the verbose output

Code: Select all

aurora -a2 -b -p -n -f -g -m -v /dev/ttyUSB0 2> ver.txt
bye

lollo
Posts: 5
Joined: Tue Jan 21, 2014 2:40 pm

Re: Inverter Info

Post by lollo » Tue Jan 21, 2014 10:47 pm

Thank you again, tomorrow i'll send him the verbose output. :D

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest