meterN 1.0

[jeanmarc]

Hello,

It's time for meterN to turn 1.0, i guess the application is mature enough

Here's the change log :

- Bug : First and lasts of the day
- Admin : Cleaner new config version message
- Admin : Redefine index(es). You can allign meter(s) that drift with real one(s) positively or negatively without bump in charts.
Beware, this might interfere with -virtual(s)- meter(s) that use previous saved values.
- Admin : Change daily value(s)

In other words, if you have a meter that need an index correction, let's say you read 100 liters and mN return 110 liters :
You correct via 'Redefine' then, change your daily values and remove 10 liters

You can also use "Change daily value(s)" to fill your missing data.

Enjoy

[lueila]

Hi Jeanmarc,
nice..

I tried to alignment the signal and reduced few Wh on redefine index but changed a lot my trend both energy and power, I tried to return on my original paramenter but seems the situation goes worse
Is there a procedure to return on original parameters and take the trend again? Now energy is lost on trend but power is ok
Tks lueila

[jeanmarc]

Hi,
Well you can restore old csv there a copy in data/old/
i suppose you use a virtual meter ?

[lueila]

Thank you, found it in old.
Now it's better, I have all details, only few minutes are missing but it's ok.
I'm not sure if I use it virtual meter
I have an energy data module where I can read/recorder all electrical measurements.
lueila

[jeanmarc]

A virtual meter is only based on calculation from other meters. Let's say you have a meter that returns in/out energy another meter for a solar production: A virtual meter's script is a fake meter for the home consumption.

Depending on your script, reallignement could mess up virtual meters.

[lueila]

noted thks now all things are ok.
One point, I noted that in redefine index the labeltxt is populated with last readings if you click on save instead back (mistake) you could lost some info, is it possible put a checkbox to abilitate it, this could reduce mistake operation,
of course this is my opinion.

[jeanmarc]

Already done that, working on another release

[lueila]

Already done that, working on another release

very well jeanmarc

[jeanmarc]

Hello,

Yet another release, here's meterN1.0.1

New : Add HTTP authentication option. This allow early mN's setup via localnetwork without HTTP authentication.
Bug : Last and First values on reboot where missing
New : Filter negative meter values, some people have meter with wrong data.
Some clean up

You will need to check the security HTTP authentication and save the main config.
Bye

[lueila]

Hello,

Yet another release, here's meterN1.01

New : Add HTTP authentication option. This allow early mN's setup via localnetwork without HTTP authentication.
Bug : Last and First values on reboot where missing
New : Filter negative meter values, some people have meter with wrong data.
Some clean up

You will need to check the security HTTP authentication and save the main config.
Bye

Well done, update just done