I have configured two indicators in my meterN setup with the intention of monitoring the battery voltage of a couple of arduino wireless nodes.
Firstly, does this sound like it fits with the intended use of Indicators ?
How often are Indicators sampled/updated ?
In this case once an hour or even once per day would be adequate ...
I have so far been unable to get these indicators display any values.
The Test Command returns a valid response :-Number of indicator(s) 2
Indicator#1: Vcc(Pwr) Name: Vcc(Pwr) ID: Vcc0 mode: Value
Command: arduino-serial -q -b 115200 -p /dev/ttyUSB0 -S "rvcc0" -r Unit: mV
Indicator#2: Vcc(Temp) Name: Vcc(Temp) ID: Vcc1 mode: Value
Command: arduino-serial -q -b 115200 -p /dev/ttyUSB0 -S "rvcc1" -r Unit: mV
On both the Index page and on the Dashboard page, the values displayed for Vcc(Pwr) and Vcc(Temp) are always '... mV'Vcc0(3303*mV) is a valid entry !
Am I missing something here ?
Does anyone have indicators working ?
Currently on meterN 188.8.131.52
Same issue with 8.2.1